How can you elaborate on the tool configuration of the slitting line?

The slitting machine, also known as the slitting line, the slitting machine and the slitting machine, is a kind of metal cutting device. Uses: It is suitable for longitudinal shearing of metal strips and rewinding the slit strips into rolls. Advantages: easy to operate, high cutting quality, high material utilization, stepless speed regulation of cutting speed. Structure: It consists of unwinding (unwinding), feeding positioning, slitting and slitting, and winding (winding). Applicable materials: tinplate, silicon steel sheet, aluminum strip, copper, stainless steel sheet, galvanized sheet, etc. Applicable industries: transformers, motors, home appliances, automobiles, building materials, packaging industry, etc.

The following slitting line manufacturer gives you a detailed introduction to how the tool configuration of the slitting line is precise:

The configuration mode of the narrow-cutting tool with poor precision is to first break the burr formed by the gap parallelity caused by the bad parallelism and flatness of the tool, and only the thickness tolerance is too large to reach * * Glitch formed by the gap value required.

The thickness tolerance of such tools is often around 0.001~. For example, cutting a 0.002 mm thick metal sheet requires a gap of 0.002 mm. So how can a tool with a thickness tolerance of 0.001 mm meet the requirements of a 0.02 mm gap? Isn't this the same as how the goods that are priced at the end of the cents can be settled with a coin?

The accuracy is slightly better than the configuration mode of the slitting tool. The thickness tolerance of this tool is usually around .0.005mm. Plastic shims are generally not used when using such tools, but operators often worry that too many blades are stacked together, which increases the cumulative error. Therefore, many blades, composite rubber spacers, and distance rings are generally prepared, and then Pick the right size tool in the base unit. This configuration method requires a lot of time and tool inventory, and the effect may not be satisfactory.

The configuration mode of the high-precision slitting line tool is because the precision of the tool is in the same level, so it can configure the gap required for the precise cutting of the steel sheet coil as the block gauge in the measuring chamber of the machine manufacturer. width. Coupled with software support, it can also effectively accumulate the cumulative error of all the cutting units between the upper and lower axes. In addition, due to the high precision, the rigidity of the entire cutting system is particularly good.